Switching and Routing Pedals

Radial Engineering

Twin-City Active Amp Switcher

The Twin-City™ is an active amp selector that lets you connect any two guitar amps and switch between them or drive them both simultaneously without noise, loss of gain, or any degradation to your natural guitar tone. Twin-City Active Amp Switcher Active ABY Amp Switcher The Twin-City™ is an active amp selector that lets you connect any two guitar amps and switch between them or drive them both simultaneously without noise, loss of gain, or any degradation to your natural guitar tone. Photos Active ABY amp switcher & Class-A buffer Isolated output eliminates hum and buzz 180° polarity reverse to phase-match amps Drag Control load correction for natural tone + More Features Active circuitry for noise-free switching The Radial Twin-City uses a class-A input buffer to drive the amp outputs, which reduces susceptibility to noise and allows for completely silent switching on stage. To eliminate hum and buzz from ground loops, the Twin-City is equipped with an isolation transformer on output-B, along with a ground lift switch and 180⁰ polarity reverse switch that ensures both amplifiers play back in phase with each other. At the input, Drag Control load correction allows you to recreate the natural load on the pickups as if you were connected directly to a tube amplifier, allowing the natural tone of your instrument to shine through.

Old Blood Noise Endeavors

Split / Meld

Split | Meld Is a passive, non-summing, non-destructive way to manage parallel dual-mono and stereo signal paths. Split | Meld is an audio routing solution. Split | Meld consists of 2 pairs of a TRS (or Stereo) Jack & 2 TS Mono jacks. The TIP & RING of each TRS jack is routed to a corresponding Mono jack. Use SPLIT | MELD to route your parallel signal path in a myriad of ways—Especially useful with devices that have TRS input & dual-mono output.