Controls:
Press and hold the center button while turning the knobs to activate the alternate controls (shown in parentheses.)
LEVEL - Adjusts the overall output level of the Defender. The pedal has quite a bit of volume on tap, enough to overdrive your amp.
DRIVE - Controls the amount of drive, saturation, and distortion of the effect.
(WARP) - Adjusts the speed of the WARP control. With this control at minimum the Defender will warp between the red and blue settings instantly. With the control at maximum the pedal will take approximately 10 seconds to warp.
LIGHT - Controls the treble or brightness of the distortion effect or the cutoff frequency of the filter if FLT is selected.
(BLEND) - Mixes the clean signal (fully counter-clockwise) with the distorted signal (fully clockwise.) This is a really crucial control for using the Defender with bass or low-tuned guitars, allowing you to dial in some clean signal to increase the articulation.
MATTER - Controls the bass or depth of the distorted tone or the resonance / feedback of the filter if FLT is selected.
(TWEAK) - Adjusts the special effect for each distortion mode. Varies for each effect, check out the descriptions below!